![]() ![]() (See also Apple's early 2009 Apple AirPort Networks manual for more information. In bridge mode, the base station connects to a. Given my problems with a modern but non-Apple base station and an older AirPort Express, I assume a wireless-to-wired bridge needs Apple's WDS capabilities (and hence when reading question 2, I assume one should take question 1 into account as well). You can configure the AirPort Express base station in your office as an access point via wireless bridging. Question: Can AirPort Express act as a bridge?Īnswer: AirPort Express can act as a bridge in three different ways If it is set up as a WDS remote or relay station, it can bridge the wireless network to wired clients. But it can wirelessly extend the range of a WDS network that is being hosted by an AirPort Extreme Base Station or another AirPort Express. Question: Can AirPort Express wirelessly extend ("repeat" or "rebroadcast") the network of a third-party access point?Īnswer: No. According to Apple's AirPort Express frequently asked questions: (Note that the Express, which ships with firmware 7.3, must also be updated to firmware 7.3.1 for this feature to appear.)Įarlier versions seem to support this kind of bridging as well, but your mileage may vary when not using an Apple base station (so, I don't expect problems for your situation). The feature should work with any wireless network: a, b, g, or n and 5GHz or 2.4GHz. To activate ProxySTA, you must set up the Express to join a wireless network and then enable the Allow Ethernet Clients setting both settings are located in the Wireless tab of AirPort Utility. Unfortunately, this feature isn’t documented and doesn’t appear by name anywhere in AirPort Utility. In this mode, the Express acts as a wireless-to-Ethernet bridge, extending your wireless network to wired clients. The Express is also the first AirPort Base Station to provide a new feature called ProxySTA. For the March 2008 802.11n version Macworld writes (emphasis mine): Normally, you never want two routers both trying to provide DHCP and NAT services. ![]() Just based on my experiences, depending on the size of your home, I would try the extreme as a standalone wifi source and make sure you leave the. Technically, the setting is actually 'Off (Bridge Mode)', which means that the DHCP and NAT routing services of the AirPort Extreme are turned 'Off', because you already have another router in the building that is providing DHCP and NAT services. The wireless on the connection hub is disabled. Recent versions indeed support it, but early versions might not. Using the Airport Express in bridge mode to the Bell Fibe Connection Hub and the wireless range and performace increase is a night and day difference.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |